Serial commands

These are all of the commands that can be sent over a serial interface to control your VTAP reader.

Your command interface could be a virtual COM port or serial port. The commands can be sent using your own code or a program such as TeraTerm or PuTTY-nd for instance.

For ease of use the main commands are split into three types: Data request commands, Remote management commands and Dynamic configuration commands.

Commands that are only relevant to VTAP PRO readers in Local mode are kept in a separate section VTAP PRO Local mode commands.

If you can't find the answer you are looking for try using the Search bar above.

If you prefer a complete reference document, all of this information is also available in the pdf document VTAP Settings and Commands Reference.