Wiegand LED and beep signals
By default the VTAP reader will receive and act on any LED (red and green) or beep response signals from an access controller connected by a Wiegand interface.
Note: The Wiegand interface is only available if you are using the VTAP100‑PAC‑W model.
To disable control of the VTAP LEDs or buzzer input, you can either disconnect the wires which connect the buzzer and LED pins from the controller to the VTAP reader, or set WiegandInputEnable=0. Set =01 to enable LED input only, or =80 to enable buzzer input only. The default is WiegandInputEnable=81 which enables LED and buzzer.
Related reading:
